QUICK ANSWER
Where to start
Most furnace repairs cost a few hundred dollars. Angi's 2026 data puts the national average at about $318, with most homeowners paying $133 to $505, and HomeGuide lists a typical range of $125 to $480. Small parts such as an igniter or flame sensor usually land at the low end, while a blower motor, draft inducer motor or heat exchanger can push the bill past $1,000. After-hours and weekend calls can cost up to about twice as much. These are national reference ranges, not local quotes. In Indiana, Greensburg, Latrobe or Murrysville, check the thermostat, filter and breaker first, then ask for a written price before any part is replaced.
Key points
- Angi's 2026 national data: average furnace repair about $318; most homeowners pay $133 to $505; full range about $64 to $1,475.
- HomeGuide lists a typical repair at $125 to $480, with labor at about $75 to $150 per hour plus parts.
- Common small fixes: igniter about $100 to $250 and flame sensor about $80 to $250 (HomeGuide).
- Big-ticket parts: blower motor up to about $2,000 and heat exchanger replacement $1,000 to $3,000 (HomeGuide) or $500 to $1,500 (Angi).
- Emergency and after-hours labor runs about $140 to $215 per hour, and Angi puts most emergency repairs at $300 to $1,200.
Match the furnace problem to the cost-smart next step
These observations help describe the issue, not diagnose it. Stop if conditions become unsafe.
| What is happening | Cost-smart response |
|---|---|
| No heat at night, house dropping fast or pipes at risk | Do the thermostat, filter and breaker checks, then call; the after-hours rate is usually cheaper than a burst pipe. |
| Furnace still heating but cycling or noisy, house holding temperature | Write down the symptoms and status code and book a regular-hours visit to avoid emergency rates. |
| Technician quotes a heat exchanger or other major part | Ask to see the evidence, get the price in writing and compare it with a replacement quote or a second opinion. |
| Gas smell or carbon monoxide alarm | Get everyone outside and call 911 and the gas utility first; cost questions come after the home is cleared. |
Furnace repair cost at a glance (2026 published ranges)
There is no official price list for furnace repair in Indiana County or Westmoreland County, and this website does not set or quote prices. What we can do is show the figures the large national cost guides published, so you can tell whether a quote is in a normal range before you approve it.
Angi's 2026 furnace repair guide, based on 27,763 projects reported by its pros, puts the national average at about $318. Most homeowners pay between $133 and $505, and the full range runs from about $64 to $1,475. HomeGuide's guide gives a typical range of $125 to $480, a national average of about $300, and lists gas or oil furnace repairs at $100 to $480 and electric furnace repairs at $100 to $380.
Most bills are made of two parts: a service call or diagnostic charge, then the repair itself. Angi says small repairs are often billed as a $100 to $200 minimum rather than by the hour. Many companies apply the diagnostic charge to the repair if you approve the work, so ask about that before the technician arrives.
Furnace repair cost by part
The part that failed matters more than anything else. These are the published 2026 ranges from Angi and HomeGuide for parts and labor together. Where the two guides differ, both are shown.
Low-cost repairs (usually under $300): flame sensor about $80 to $250 (HomeGuide) or $150 to $250 (Angi); igniter $100 to $250 (HomeGuide) or $150 to $250 for a standard replacement (Angi); transformer $100 to $250 (HomeGuide) or $100 to $175 (Angi); thermocouple on older pilot-light furnaces $100 to $300; limit switch $100 to $375; relay switch $100 to $300.
Mid-range repairs (usually $200 to $800): gas valve $200 to $800 (HomeGuide) or $200 to $600 (Angi); control or circuit board $300 to $650 (HomeGuide) or $200 to $600 (Angi); flue pipe $300 to $800; thermostat $100 to $600 depending on whether it is repaired or replaced with a smart model.
Major repairs (often $500 to $3,000 or more): draft inducer motor $400 to $1,100 (HomeGuide) or $200 to $1,500 (Angi); blower motor replacement $500 to $2,300 (HomeGuide) or up to $2,000 (Angi); heat exchanger replacement $1,000 to $3,000 (HomeGuide) or $500 to $1,500 (Angi); coil replacement $600 to $2,000 or more. A stainless chimney liner for an oil or older gas furnace venting into a masonry chimney is listed at $900 to $3,800.
Emergency and after-hours furnace repair rates
No-heat calls spike on the first hard cold nights of November and through January, and that is when after-hours rates apply most. Angi says emergency furnace repair can cost up to twice as much as a regular visit, with pros charging about $150 to $215 per hour and most emergency repairs landing between $300 and $1,200. HomeGuide lists emergency HVAC labor at $140 to $210 per hour for after-hours, weekend and holiday work and notes that service fees go up in cold weather because of demand.
A concrete example: Angi lists a standard igniter replacement at $150 to $250, but $350 to $500 when it happens after hours. The part is the same; the timing changes the bill.
If the house is holding a safe temperature and nobody at home is at risk from the cold, waiting until regular hours can save money. If the temperature is falling fast, someone in the home is elderly, an infant or medically fragile, or pipes are at risk, the emergency rate is usually cheaper than a burst pipe.
Furnace out on a cold night? Call to be connected with a local heating repair pro and ask how they price the visit before they come out.
Referral service. Calls may be recorded and may be routed to an independent local service provider.
What raises furnace repair costs in Indiana and Westmoreland County
Older equipment and older homes add cost. Many houses in Indiana, Blairsville, Jeannette, Greensburg and Latrobe have furnaces that were converted from coal or oil, vent into old masonry chimneys, or sit in tight basements and crawl spaces. Brand-specific parts for older or high-efficiency furnaces cost more, and HomeGuide notes that two-stage and variable-speed systems cost more to repair than single-stage units.
Fuel type matters. Natural gas furnaces are common in town, while rural homes around Homer City, Saltsburg, Ligonier and the townships often heat with propane or oil. HomeGuide lists oil furnace service at about $120 to $600, and oil and propane systems can add tank or fuel-line work.
Distance and demand matter too. Homes far from a technician's base may pay a higher trip charge, and after a cold snap many homes call at once. HomeGuide also notes that contractors in metro areas typically charge more than rural pros, so a Murrysville quote and an Indiana County quote may not match.
Five checks before you pay for a service call
1. Thermostat: set it to Heat, raise the set point a few degrees above room temperature and replace the batteries if the screen is blank. 2. Filter: a filter packed with dust can make a furnace overheat and shut the burners off. Angi lists a new filter at about $1 to $35. 3. Power: check the furnace switch near the unit, which often looks like a light switch, and the furnace breaker. Reset a tripped breaker once; if it trips again, leave it off.
4. Fuel: make sure the gas valve to the furnace is on, the propane tank is not empty, or the oil tank gauge is not on empty. 5. Status light: many furnaces flash a code through a small window in the panel. Write it down without removing panels; it can shorten the diagnosis. Our furnace not heating guide covers these steps in more detail.
Repair or replace? When a big repair bill points to a new furnace
HomeGuide says most heating system repairs cost $100 to $600, while a new furnace replacement averages $3,500 to $7,500 or more, and it suggests replacement is usually best for units that need frequent repairs or are more than 20 years old. Angi puts typical furnace lifespan at about 15 to 30 years depending on fuel type and maintenance.
A cracked heat exchanger is the most common reason a repair turns into a replacement talk, because it can let carbon monoxide into the home. If a technician says the heat exchanger is cracked, ask to see the evidence, such as photos or a camera inspection, and consider a second opinion before you buy a new system. Our repair or replace checklist explains what to compare.
Help paying for a broken furnace in Pennsylvania
Pennsylvania's LIHEAP heating assistance program is open for the 2026-27 season from November 2, 2026 through April 23, 2027. Its crisis grants cover emergencies such as broken heating equipment or leaking lines that must be fixed or replaced. The Department of Human Services says 2026-27 crisis grants range from $25 up to a season maximum of $1,000.
If you have not received LIHEAP this season, apply first through COMPASS or your County Assistance Office; if you already received a grant, contact your County Assistance Office to report the heating emergency. Ask about it before the repair, because crisis payments must be authorized by the County Assistance Office.
What the symptoms may tell you
The thermostat calls for heat but the furnace does not start, or starts and shuts off within a few seconds.
The blower runs but only cool air comes from the vents.
You hear the inducer fan and a click, but the burners never light.
Loud squealing, grinding or banging from the furnace cabinet.
A status light is flashing a fault code, or the furnace keeps locking out after resets.
Homeowner checklist
- Check thermostat mode, set point and batteries before you call.
- Replace a visibly dirty filter using the size printed on the old one.
- Check the furnace power switch and breaker; reset a tripped breaker only once.
- Confirm the gas valve is on or the propane or oil tank is not empty.
- Write down the furnace model number and any flashing status code.
- Ask for the service call charge and after-hours rate before the technician comes out.
- Get the repair price in writing, naming the part, before work starts.
Safety first
If you smell gas, leave the house and call 911 and your gas utility from outside; do not touch light switches or the thermostat on the way out. If a carbon monoxide alarm sounds, get everyone outside first. Never remove burner or electrical panels, bypass a safety switch, or keep resetting a furnace that locks out. While the heat is off, never heat the house with a gas oven, grill or generator, and use only indoor-rated space heaters with clearance from anything that can burn.
When to involve a professional
Call a qualified HVAC technician when the furnace will not start or stay running after the basic checks, the burners will not light, you hear grinding or banging, a breaker keeps tripping, or there is any gas smell or carbon monoxide concern. Ask how they price the visit, whether the diagnostic charge is credited to the repair, what the after-hours rate is, and for a written price before parts are replaced. Prices, availability and arrival times are set by the independent provider, not by this website.
Questions to ask before agreeing to work
- What is your service call or diagnostic charge, and is it credited toward the repair if I approve the work?
- Which part failed, how did you test it, and is the price you quoted for the part and labor together?
- Is the replacement part a manufacturer part or a universal part, and what warranty covers parts and labor?
Related local pages
- Heating and cooling services
- Furnace repair in Indiana, PA
- Furnace repair in Blairsville, PA
- Furnace repair in Greensburg, PA
- Furnace repair in Latrobe, PA
- Furnace repair in Murrysville, PA
- Furnace repair in Jeannette, PA
- Furnace not heating: safety before troubleshooting
- HVAC repair or replace? A homeowner decision checklist
- Heat pump not heating? What to check before you call
- Carbon monoxide alarm going off? What to do right now
- Emergency plumber cost in Western PA
Frequently asked questions
How much does furnace repair cost in Western PA?
There is no official local price list. Angi's 2026 national data puts the average at about $318, with most homeowners paying $133 to $505. HomeGuide puts typical repairs at $125 to $480. Your price in Indiana or Westmoreland County depends on the failed part, the furnace type and whether the call is after hours.
How much does an emergency furnace repair cost?
Angi puts most emergency furnace repairs at about $300 to $1,200, with after-hours labor around $150 to $215 per hour. HomeGuide lists emergency HVAC labor at $140 to $210 per hour. Emergency work can cost up to twice as much as the same repair during regular hours.
What is the most common furnace repair?
Angi says the igniter fails more than any other furnace part, at about $150 to $250 to replace during regular hours. Flame sensor cleaning or replacement is another common, low-cost fix, at about $80 to $250.
Is it worth repairing a 20-year-old furnace?
Sometimes. A small repair such as an igniter or flame sensor is usually worth it. HomeGuide suggests replacement is often better for units older than 20 years that need frequent repairs, or when a major part such as the heat exchanger fails. Ask for both prices in writing and compare.
Can you connect me with a furnace repair pro in Indiana, Greensburg or Murrysville?
Yes. Our referral service covers Indiana County and Westmoreland County, including Indiana, Blairsville, Homer City, Greensburg, Latrobe, Jeannette, Ligonier and Murrysville. Calls may be recorded and may be routed to an independent local service provider, who confirms availability, timing and price with you.
Research references
Public information for additional reading, not endorsements or individualized professional advice.